Advertisement

Heat Pump Emergency Heat: When to Use It and Leave It Off

Emergency heat is a backup-only setting, not something to use every time the house feels chilly. This article shows when to flip it on, when to stay in normal mode, and what to check first if the heat pump is in defrost, auxiliary, or recovery mode.

Heat Pumps 6 min read
home thermostat
Advertisement

Emergency Heat is the backup-only setting on a heat pump thermostat. Use it when the heat pump can’t provide heat and you need the backup heat source to carry the house, such as when the outdoor unit is damaged, the compressor won’t run, or an HVAC tech has told you to run backup heat only.

The short answer: when to use Emergency Heat

Emergency Heat is for times when normal heat pump mode can’t do the job. Use it as a temporary fallback when the system cannot heat the house on its own.

That usually means the outdoor unit is out of service, the compressor will not run, or a technician has told you to switch over. A cold house by itself is not enough reason to flip it.

For example, if a storm damaged the outdoor unit and the system can’t run safely, Emergency Heat may keep the house warm until repairs are made. If the system is still operating normally, leave it in standard heat mode.

What Emergency Heat actually turns on

Emergency Heat tells the thermostat to stop depending on the heat pump and use backup heat instead. In many homes, that backup is electric heat strips; in some systems, it is a furnace or another auxiliary heat source.

That backup heat can warm the house, but it usually costs more to run because the efficient part of the job is no longer being done by the heat pump. On many setups, the thermostat’s emergency heat switch changes the control logic, but the outdoor unit still needs service if the compressor is dead.

When Emergency Heat is the right move

A good rule is simple: use it when normal heat pump operation cannot provide heat at all, and you need a temporary fallback.

SituationEmergency Heat?Why
Outdoor unit is visibly damaged after a stormYesThe heat pump may not be able to operate safely
Compressor will not start and the house is getting coldUsually yesBackup heat may be the only working heat source
Outdoor unit is buried, crushed, or badly iced and not recoveringSometimesUse it if normal operation is clearly unavailable
Technician told you to run backup only until serviceYesFollow the service instruction

A common case is a temporary outdoor-unit problem where you need heat now, even though the system needs repair.

When not to use it, even if the house is cold

Do not use Emergency Heat just because the air from the vents feels lukewarm or the house is warming slowly. Heat pumps often feel less dramatic than gas furnaces, and that does not mean they are failing.

Skip Emergency Heat during a normal defrost cycle. During defrost, the outdoor unit can look odd and the air may feel cooler for a few minutes while the system clears ice.

Also leave it off during recovery after a thermostat setback, or in mild cold weather when the heat pump should still be able to run. If auxiliary heat is already helping, that is not the same thing as Emergency Heat.

Emergency Heat also is not the right answer if the problem is outside the thermostat setting itself, such as a tripped breaker, a clogged filter, a blocked outdoor coil, or a unit that is simply waiting to finish a normal cycle.

Emergency Heat vs auxiliary heat

Auxiliary heat, often shown as aux heat or an aux heat indicator, is backup heat that comes on automatically when the thermostat thinks the heat pump needs help. Emergency Heat is different: it usually tells the thermostat to stop using the heat pump and run backup heat only.

That difference matters. AUX heat can be normal support during cold weather or recovery. Emergency Heat is the manual backup setting for when the heat pump should be taken out of the equation.

If the thermostat shows AUX heat, that can mean the system is working harder, not that it has failed. If you switch to Emergency Heat, you are choosing backup heat only, which is a bigger step.

Quick checks before you switch modes

Before you flip the thermostat to Emergency Heat, do the fastest safe checks first.

  • Confirm the thermostat is set to Heat, not Cool or Off.
  • Check the breaker for the indoor and outdoor equipment.
  • Look at the air filter; a badly clogged filter can reduce heat.
  • Check the outdoor unit for snow, ice, leaves, or other blockage.
  • Watch for a few minutes to see whether the system is in a defrost cycle or recovering from a thermostat setback.

If the outdoor unit is simply defrosting, give it a little time. If it stays dead, trips a breaker again, or never moves out of that state, stop treating it like a normal operating cycle.

If the thermostat has recently changed from a lower temperature to a much higher one, the system may be in recovery and using auxiliary heat to catch up. That is different from a true emergency-only situation.

A home thermostat is shown with an outdoor heat pump unit outside a house.

What to expect after you turn it on

Once Emergency Heat is on, expect backup heat to carry the house for a while, but not to behave like a normal heat pump. The air may feel warmer at the vents if electric strips are running, but the system can also cost more to operate and cycle differently.

It is a temporary workaround, not a repair. If you leave it on overnight or for several days, the house may stay comfortable, but you are still avoiding the underlying heat pump problem.

When to call an HVAC pro

Call for service if the outdoor unit will not run, the system keeps icing up, heat is weak in normal mode, breakers trip, or Emergency Heat is the only way you can get heat.

Those are signs that the problem is bigger than a thermostat setting. If you are unsure whether the issue is the compressor, the thermostat, wiring, or the outdoor unit, a pro can sort that out without guesswork.

Conclusion

Emergency Heat is for backup-only situations, not for a house that just feels slow to warm up. If the system is still running normally, leave it alone and use the quick checks above before you change modes.

Frequently Asked Questions

Can I leave Emergency Heat on overnight?

Yes, if the heat pump is out of service and you need heat, but treat it as a temporary backup setting. If it becomes the only way to keep the house warm, schedule service soon because the real problem still needs repair.

What if the outdoor unit looks frozen?

If it is in a normal defrost cycle, wait and watch for it to recover. If it stays iced up, never starts, or keeps freezing again, Emergency Heat may help in the short term, but you should call for service.